Gas Connector 1/2'' OD x 36'' L Coated Stainless Steel - EASTMAN CSSD44R36 Alternative UP: C026613167602, 091712056027, 669771051187 BRAND NEW! THE PACKING MIGHT BE SEALED OR OPENED AND INSPECTED Corrugated stainless steel with corrosion-resistant coating Safety+PLUS EFV helps protect against gas fires and explosions 1/2 in MIP connection to gas ball valve outlet or gas supply stub-out Safety+PLUS EFV has no parts that can break or misalign over time for 24/7 protection Safety+PLUS EFV is omnidirectional and can be installed in any position, vertical or horizontal Safety+PLUS EFV installs like a standard gas fitting, no special tools required Safety+PLUS EFV is 100% factory performance tested ProCoat coating corrosion-resistant to harsh chemicals as well as UV rays and salt Gas connector is 100% leak tested Application: For indoor and outdoor use and used to install 4-burner gas ranges, cook-top, dryers and water heaters Material: Stainless Steel Suitable for: Low Pressure Natural and LP Gas Piping Systems EASTMAN/BrassCraft's Safety+PLUS gas connector combines patented excess flow technology with the advanced corrosion resistance, to provide a safer gas connector for your home and family. In the event of a gas line rupture or disconnect, the Safety+PLUS excess flow valve (EFV) restricts gas flow at the appliance to a non-hazardous level. This immediate action helps avert the potential for a dangerous release of gas into the home. Gas is controlled only at the point where the problem exists, the rest of your system will continue to function. Safety+PLUS EFV automatically resets once the gas line is properly repaired. BrassCraft's stainless steel gas connector also features a proprietary polymer coating designed to withstand prolonged exposure to harsh household cleaning, plumbing repair and masonry products as well as UV rays and salt. Unlike conventional dipped or sprayed coatings, the ProCoat coating is baked directly on the connector surface at high temperatures to provide a uniform coating over the entire length of the connector. The coating is applied only after the connector has been 100% leak tested to provide complete corrosion resistance.