New parts. Combo set ALL 8 parts made for the VINTAGE KitchenAid meat grinder Fits the original aluminum version that was made in the 1970's and 1980's These plates are made specifically for the KitchenAid/Hobart heavy aluminum meat grinder that was produced in the 1970's and 1980's. They will NOT FIT any other meat grinder by KitchenAid. Stainless steel parts. See photos in listing of the meat grinder that these parts fit. Meat grinders are NOT included in purchase. The meat grind sizes in this set 1/8" (3mm) very fine mince 3/16 (4.5mm) small hamburger 1/4" (6mm) typical hamburger 5/16" (8mm) typical sausage 1/2" (12mm) typical chili 5/8" (16mm) coarse grind 2-hole plate. For stuffing sausage into the tube AND a New Stainless Steel knife The plate measurements are: 1 15/16" (49 mm)" across 3/16" (4.5 mm) thick 5/16" (8 mm) center hole Stainless steel part. New Replacement Meat Grinding plate For KitchenAid Meat Grinder. Seller Note: Please do not purchase these parts if you do not have one of the original metal meat grinders as the photos show. Fits the original aluminum meat grinder by KitchenAid . This part will NOT fit any other meat grinder on the market. *Grinder attachment pictured represent one of the grinder attachments that this plate fits. It is not included in the purchase. This purchase is for the new parts only. This part will NOT fit the new plastic FGA or the Chefs Choice attachment. Visit our complete store at https://www.ebay.com/str/butcherbaker