Make that large clock with this high torque sweep quartz (silent sweep) movement with extended shaft for extra clearance when running long balanced hands and 9-1/4" (#8) balanced black fancy sword metal hands. High torque motor with 9/16" threaded shaft x 5/16" in diameter. Requires one "AA" battery (not incl.), includes all mounting hardware. This is a continuous motion high torque motor, no stepping of gears, most quiet high torque motor available. Those of you with keen hearing will greatly appreciate it's quietness. Idea's unlimited. See my other auctions for other styles and lengths. NOTE: minute hand is measured from center of mounting hole to end tip of hand. Minute hand measures 9-1/4" from center of mounting hole to end tip, total length 12-7/8" end to end and is balanced. Hour and measures 7-1/4" center of mounting hole to end tip, total 7-3/4" end to end Motor 2-1/8" sq x 5/8" case thickness Threaded shaft length 9/16" (11mm), total length including hand stem is 15/16" including hand stem 3 yr factory warranty on defects requires one "AA" battery (not incl.) includes all mounting hardware (rubber brass washers, hex and closed nuts) I also have 1/4" 7/16" threaded shafts, optional in place of the furnished 9/16" shaft. If so, please advise. Hands are made of metal, may be painted any color...use a primer then color coat NOTE ON MEASURING:: Shaft length is the threaded portion "B" (in picture), , not including hand stem "A". "B" is the threaded portion that must pass thru your clock face, plus a couple of threads to attach retaining (hex) nut. . HANDS: minute hand measured from end tip to center of mounting hole. MEASURING DIAL FOR HAND SIZE: measure from top of #12 to bottom of #6, divide in half. This will give your approx. minute hand length. Please verify your mailing address. Please see all my other listings: https://www.ebay.com/sch/cp20111/m.html? trksid=p3692 I will attached photo of assembly in my notice of purchase email. PICTURED WITH HEADY DUTY HANGER.....NOT INCLUDED