Genuine Ford Motorcraft. Arrives fully assembled and ready for installation. Connector Assembly Includes: Connector Housing (20% glass reinforced. Knockoff Chinese version: not so much) Grommet cap PLR (Primary Lock Reinforcement Device) CPA (Connector Position Assurance Device) Mat seal Ring seal ELECTRICAL SPECIFICATIONS (Cheap Chinese connectors actually allow arcing) Voltage: 250 Volts Current: 22.0 Amps Contact Resistance: 10 milliohms max. Dielectric Withstanding Voltage: 500 Volts DC Insulation Resistance: 20 Megohms min. You will want to reuse your factory original wiring and terminals. 1. Simply remove the wire/terminal assemblies from the old connector (feel free to break it apart as you have new ones! Just be careful to not damage your wire/terminals). 2. Do note the position of each wire in relation to the connector. 3. Insert the wire/terminals into the new connector. You should hear an audible click. 4. From the front of the connector, push the white PLR inward to lock the terminals in place. 5. Install connector on coil. 6. Push the red CPA forward to lock the connector in place. 7. Rinse and repeat with each connector. 8. Done. APPLICATIONS: Ford Flex 2010 - 2012 Ford Taurus 2010 - 2012 Lincoln MKS 2010 - 2012 Lincoln MKT 2010 - 2012 Ford F-150 2015 - 2017 Ford F-150 2015 - 2017 Ford Edge 2015 - 2018 Ford Mustang 2015 - 2023 Lincoln Navigator 2015 - 2023 Ford F-250 Super Duty 2017 - 2023 Leads: 3. Driving lamp. Intake Manifold Runner Controller. Water In Fuel Sensor For Daytime Running Lamps or Interchangeable with WW 1261.