Order 4 or more connectors and receive a fee roll of Nashua wire harness tape! Please compare your original connector to ensure this will work on your specific application. There are 3 versions of this connector. The three connector housing colors are LIGHT GRAY, DARK GRAY and BLACK. WPT-931 is black I have included a picture showing all three to aid identification. Genuine Ford Motorcraft. Arrives fully assembled and ready for installation. Picture showing the connector taken apart is to demonstrate all of the included components as specified by Ford. I have also included a connector diagram from the Ford Service Manual for reference. Each Connector includes Includes 2 wire terminals ELECTRICAL SPECIFICATIONS Voltage: 250V Current: 22.0A Contact Resistance: 10 milliohms max. Dielectric Withstanding Voltage: 500V DC Insulation Resistance: 20 Megohms min. You will want to reuse your factory original wiring. 1. Simply remove the wire/terminal assemblies from the old connector (feel free to break it apart as you have new ones! Just be careful to not damage your wire/terminals). 2. Do note the position of each wire in relation to the connector. 3. Insert the wire/terminals into the new connector. You should hear an audible click. 4. From the front of the connector, push the white PLR inward to lock the terminals in place. 5. Install connector on coil. 6. Push the red CPA forward to lock the connector in place. 7. Rinse and repeat with each connector. 8. Done.